Products Map
-
Result pages:
123
Header Sleeve for LO206 / Animal - Sold per foot
SKU: SKU722971
This is not your typical low quality header sleeve! Pre-cut to 20" to fit the Briggs LO206 spec RLV 5507 header and features heavy wall braided fiber sleeve, capable of operating at a continuous temperature of 1000°F (538°C). Clamps and header NOT included. Sold per foot.
Header Sleeve WITH Clamps for LO206 / Animal, Pre-cut 20"
SKU: SKU72297
This is not your typical low quality header sleeve! Pre-cut to 20" to fit the Briggs
LO206 spec
RLV 5507 header and features heavy wall braided fiber sleeve, capable of operating at a continuous temperature of 1000°F (538°C). Two high quality solid band hose clamps included.
NOTE: FASTECH strongly urges that the application of this header wrap to be no closer to the flange than 1-1/2” so that heat may dissipate more easily from the head.
Heavy Duty E-Clip for Grooved Hardware (10-Pack)
SKU: SKU24879
Much more durable than the standard wire-style clips. Used on all ItalKarts, Intrepids and any other karts that have grooved hardware. For 1mm wide groove, up to 4mm groove diameter.
Hegar R4 & SK-1 Pipe & Silencer Mount Kit - (Fits 2001 CR125)
SKU: SKU1507
The Hegar mount is the hottest pipe mount. Front and rear brackets and stainless steel cradles ready to install on your spec Honda CR 125. Fits the RLV R4 or the SKUSA Pro Circuit SK-1 pipe with 2001 cylinder.
$89.95
Market price: $99.95
save 10%
High Quality Stainless Hose Clamps (50-70mm) - Filter/Airbox
SKU: ID6521
High quality stainless steel hose clamp also known as smooth band clamps, these have a non-perforated band with rolled edges to prevent damage to hose and tube. Band is 3/8" wide and 0.024" thick. Tighten screw with a slotted screwdriver, Phillips screwdriver, or 9/32" (7 mm) hex nut-driver. 50-70mm.
High Quality Stainless Hose Clamps - Rolled Edge
SKU: ID652
12-20mm fits 1/2" hose, 16-25mm fits 5/8" Hose, 16-27mm fits 3/4" Hose. High quality stainless steel hose clamp also known as smooth band clamps, these have a non-perforated band with rolled edges to prevent damage to hose and tube. Band is 3/8" wide and 0.024" thick. Tighten screw with a slotted screwdriver, Phillips screwdriver, or 9/32" (7 mm) hex nut-driver.
Hilliard Drive Gear (Needle Bearing Style) - #219
SKU: SKU678001
For Fire or Flame clutches. Needle bearing NOT included. 8444-9U-034 Bearing & Race required to update Flame "bushing" style drive gear to "Needle Bearing" style drive gear. Compatible with Flame drum.
Hilliard Drive Gear (Needle Bearing Style) - #35
SKU: SKU697581
For Fire or Flame clutches. Needle bearing NOT included. 8444-9U-034 Bearing & Race required to update Flame "bushing" style drive gear to "Needle Bearing" style drive gear. Compatible with Flame drum.
-
Result pages:
123