Home :: Weight / Lead Ballast

Weight / Lead Ballast

Products

White Rubber Coated Lead Weight
3 pound weight 5 pound weight 10 pound weight
White Rubber Coated Lead Weight
SKU: WHT3

High quality, durable rubber coated lead weights used as ballast to meet the minimum weight. Most organizations now require all weight to be white. NOTE: Weights are UNDRILLED, not actual pic shown. See rules for mounting instructions. Hardware NOT included.

NOTE: Anything more than about 10 pounds will ship in a US Postal Flat Rate box to save on shipping.

WARNING: This product contains a chemical known by the State of California to cause cancer/birth defects or other reproductive harm.

$15.00
Select Weight
Qty (21 available)
Weight Hardware Kit
Weight Hardware Kit
SKU: SKU2715
Includes:
One 8mm Flat Head Bolt, pre-drilled
One Re-usable safety clip
One 8mm wide washer
Two 8mm Nylock
One Aluminum Finish Washer (Black or Titanium)
$6.95
Select Color
Select Bolt Length
Qty (338 available)
MTE SAFTBLOK Safety Wire Drill Jig Tool
MTE SAFTBLOK Safety Wire Drill Jig Tool
SKU: SAFTBLOK-METRIC

Safely and easily drill bolts for safety wire with the MTE SAFTBLOK. Select between Metric & American thread.

Metric: 6x1.0, 8x1.0, 8x1.25, 10x1.25, 10x1.5mm

American: 1/4, 5/16 and 3/8 National Fine and National Coarse. 

 

PRO-Tip: Use a drill press with the MTE jig in a small vise, the jig doesn't need to be secured to the press. Use an allen wrench to keep bolt from spinning in jig. Add 1-drop cutting fluid to hole in jig, use light steady pressure on press. Apply pressure and release to allow fluid to seep in hole. Half way through, add 1-drop of fluid and continue though. As it gets close to pushing through, continue with steady pressure straight through or else bit will catch and snap. Do this properly and drill 30+ Grade_8.8 bolts with one drill bit. Without a drill press, expect to break many drill bits.

$29.95
Select Type
Qty (43 available)
Cobalt Drill Bits for MTE Safety Wire Jig
Cobalt Drill Bits for MTE Safety Wire Jig
SKU: SKU2459
High quality Cobalt drill bits. Perfect size for the MTE jigs, 1.8mm. PRO-Tip: Use a drill press with the MTE jig in a small vise, the jig doesn't need to be secured to the press. Use an allen wrench to keep bolt from spinning in jig. Add 1-drop cutting fluid to hole in jig, use light steady pressure on press. Apply pressure and release to allow fluid to seep in hole. Half way through, add 1-drop of fluid and continue though. As it gets close to pushing through, continue with steady pressure straight through or else bit will catch and snap. Do this properly and drill 30+ Grade_8.8 bolts with one drill bit. Without a drill press, expect to break many drill bits.
$4.00
Qty (9 available)