3 required for clutch center to starter gear. Sold individually.
These work perfect on the right side to clear air filters, airboxes, headers, pipes, etc. High quality round style stainless steel seat struts. Won't rust! Measured Hole-to-Hole.
Ultra lightweight, less prone to cracking and won't rust! Saves roughly 40% weight. Measured Hole-to-Hole.
80mm wide adjustable strap prevents tires from stretching while popping the bead. Fits 230-300mm (9 to 11-3/4") overall diameter.
Your tire changing troubles are over! Here is a machine that can quickly and easily change the tires on your kart with no damage to rims or tyres.
30mm diameter, 33mm length, w/ 3x58mm international pattern. 1-pair, 2 hubs.
The Sharkshifter Adjustable CR125 Engine mount offers the following features.
* Anodized 6061 T6 Aluminum Alloy Engine mount
* Chassis clamps designed for 1 bolt per clamp
* Adjust the engine from left to right for proper clearance approximately 6mm to the left and 12mm right from center More adjustment then any other mount
*Engine Mount sits the rear of the engine up to 1" lower most other mounts
- Hardware securing engine to the mount is the proper sizes to match the Honda Cases 10mm front case bolt 12 mm rear case bolt with proper thru case Machined Alum Spacers
* Proper machining from front to back, engine will not be twisted when mounted to a straight frame.
* Proper radius on frame contact point
* Left side of rear engine mount machined to allow for chassis cross tubing weld clearance.You will not find a better motor mount . With the Sharkshifter factory Pricing. $199.00
This is only a reference, for some chassis below. Contact your chassis Supplier for proper frame rail sizes.
CRG, GP, Zanardi, DR, Aluminos, Maranello - 90mm spacing
Tony, Kosmic, FA, Italkart, Intrepid, Arrow, Praga, Birel , ART: 92mm spacing
Aluminum shift rods are tapped for 8mm rod ends at each end (one left hand, on right hand), making it easy to adjust your shift linkage to an ideal position. Rod is 19.5 inches long to fit any kart, and can be cut to a shorter length if needed.
Tired of un-bolting the side pod bolts??? Use these instead of the nerf bar bolts for a quick release. Replaces 6mm nerf bar bolts.
Pre-molded high quality 3-ply silicone hose, 18mm inner diameter.
Fits Righetti K879 and old SKM EVO1 rear calipers. Sinter Red 222 compound. (Enough for 1-caliper)