The Quick Change Solution for sprocket gear changes! NOTE: HUB SOLD SEPARATELY
- Simple 1, 2, 3 installation!
- 1 - Install wheel hub on the axle
- 2 - Attach Pin-It Sprocket System to the wheel hub
- 3 - Install sprocket and chain
- Built-In Chain Guard
- No more fussing with a separate or plastic chain guard. It's partially built into the Pin-It Sprocket!
- Pin technology replaces nuts/bolts allowing for simple gear changes seconds!
- Pin-It Sprocket system is equipped with "True Float Technology" allowing the sprocket to float up to .040" horizontally
- Made from Billet Aluminum
- 200mm guard diameter.
- Works with axles 1-1/4", 30mm, 40mm, 50mm axles, HUB REQUIRED.
- Bolts directly to any Metric or American (standard) hub (sold separately)
- NOTE: if using an existing wheel hub, double check to see if the axle will pass ALL THE WAY through the hub, most hubs WILL NOT allow axle to pass through.
- Backed by a 6-month manufacturer's warranty
- NOTE: HUB SOLD SEPARATELY
* Note - While many customers have successfully used lightweight gears be advised that due to
their thinner design, your setup may float beyond the .040" tolerance that is built into the
Pin-It Sprocket system. For that reason, we typically recommend the standard "red" split
gear sprockets.
